REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

2. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

   
   

   1. 

      Engage the guide and 6 claws to install the rear door belt moulding assembly as shown in the illustration.

3. INSTALL REAR DOOR GLASS ASSEMBLY

   Click here

4. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

5. INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

   Click here

6. INSTALL REAR DOOR NO. 1 VENT SEAL

   Click here

7. INSTALL REAR DOOR GLASS RUN

   Click here

8. CONNECT REAR DOOR WEATHERSTRIP

   Click here

9. INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

10. INSTALL REAR DOOR ARMREST SET BRACKET

    Click here

11. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

12. INSTALL REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

    Click here

13. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

14. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

15. INSTALL REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

16. INSTALL DOOR PULL HANDLE COVER

    Click here

17. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

18. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

19. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

20. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

21. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

22. INSPECT POWER WINDOW OPERATION

    Click here