REAR DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

   Click here

3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

   Click here

5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

   Click here

6. REMOVE DOOR PULL HANDLE COVER

   Click here

7. REMOVE REAR DOOR NO. 1 STIFFENER CUSHION

   Click here

8. REMOVE COURTESY LIGHT ASSEMBLY

   Click here

9. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

10. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

11. REMOVE REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

    Click here

12. REMOVE REAR DOOR ARMREST SET BRACKET

    Click here

13. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

14. DISCONNECT REAR DOOR WEATHERSTRIP

    Click here

15. REMOVE REAR DOOR GLASS RUN

    Click here

16. REMOVE REAR DOOR NO. 1 VENT SEAL

    Click here

17. REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

18. REMOVE REAR DOOR QUARTER WINDOW GLASS

    Click here

19. REMOVE REAR DOOR GLASS ASSEMBLY

    Click here

20. REMOVE REAR DOOR BELT MOULDING ASSEMBLY

    
    
    1. 

       Text in Illustration

       *1	Protective Tape

       Put protective tape around the rear door belt moulding assembly.

    2. Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and guide to remove the rear door belt moulding assembly as shown in the illustration.