FRONT DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  5. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  7. REMOVE DOOR PULL HANDLE COVER

    Click here

  8. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  9. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  10. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  11. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

  12. REMOVE FRONT DOOR ARMREST SET BRACKET

    Click here

  13. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  14. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  15. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY


    1. A0005K8E04
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front door belt moulding assembly.

    2. Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and guide and remove the front door belt moulding assembly.