REAR DOOR WINDOW FRAME MOULDING INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR DOOR WINDOW FRAME MOULDING SUB-ASSEMBLY

   
   

   1. Engage the guide and claw of the rear door window frame moulding sub-assembly to the door frame.

      

   2. Using an air riveter or hand riveter with a nose piece, install the rear door window frame moulding sub-assembly with 8 new rivets.

      Tech Tips

      If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

      Note

      
      

      • 

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

        Text in Illustration

        *1	Riveter
        *2	Mandrel
        *a	Incorrect

      • 

        Confirm that the rivets are seated properly against the moulding.

        Text in Illustration

        *1	Riveter
        *a	Incorrect

      • Do not tilt the riveter when installing the rivet to the moulding.

      • Do not leave any clearance between the rivet head and moulding.

      • 

        Do not leave any clearance between the moulding and door frame. Firmly hold the 2 items together while installing the rivet.

        Text in Illustration

        *1	Riveter
        *a	Incorrect

2. INSTALL REAR DOOR FRONT WINDOW FRAME MOULDING

   Tech Tips

   When installing a new rear door front window frame moulding, heat the vehicle body and rear door front window frame moulding using a heat light.

   Heating Temperature

   Item	Temperature
   Vehicle Body	40 to 60°C (104 to 140°F)
   Moulding	20 to 30°C (68 to 86°F)

   Note

   Do not heat the vehicle body or rear door front window frame moulding excessively.

   
   

   1. Clean the vehicle body surface.

      
      

      1. Using a heat light, heat the vehicle body surface.

      2. Remove the double-sided tape from the vehicle body.

      3. Wipe off any tape adhesive residue with cleaner.

   2. Install a new rear door front window frame moulding.

      
      

      1. Using a heat light, heat the vehicle body and rear door front window frame moulding.

      2. Remove the release paper from the rear door front window frame moulding.

         Tech Tips

         After removing the release paper, keep the exposed adhesive free from foreign matter.

      3. 

         Text in Illustration

         *1	Double-sided Tape
         *2	Caulking Sponge

         Engage the guide and clip and install a new rear door front window frame moulding.

3. CONNECT REAR DOOR WEATHERSTRIP

   
   

   1. Engage the guide and 7 clips and connect the rear door weatherstrip.

4. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

   Click here