HEADLIGHT LEVELING ECU INSTALLATION

PROCEDURE

1. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY

   
   

   1. Install the headlight leveling ECU assembly with the bolt.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

   2. Engage the clamp.

   3. Connect the connector.

2. INSTALL ECU INTEGRATION BOX RH (for RHD)

   Click here

3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)

   Click here

4. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

5. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

6. INSTALL INSTRUMENT SIDE PANEL

   Click here

7. INSTALL FRONT DOOR OPENING TRIM COVER

   Click here

8. INSTALL COWL SIDE TRIM BOARD

   Click here

9. INSTALL FRONT DOOR SCUFF PLATE

   Click here

10. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL

    Click here

11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (for RHD)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

12. INSTALL LUGGAGE TRIM SERVICE HOLE COVER (for RHD)

    Click here

13. INSPECT SRS WARNING LIGHT (for RHD)

    Click here

14. INITIALIZE HEIGHT CONTROL SENSOR SIGNAL

    Click here

15. ADJUST HEADLIGHT AIMING

    Click here