STOP LIGHT SWITCH INSTALLATION

PROCEDURE

1. Click here

   INSTALL STOP LIGHT SWITCH ASSEMBLY

   
   
   1. 

      Insert the stop light switch assembly until the threaded sleeve hits the pedal.

      Note:

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

   2. 

      Turn the stop light switch assembly 1/4 clockwise to install it.

      1.5 N*m	15 kgf*cm	13 in.*lbf
      or less

      Note:

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

   3. Connect the connector.

   4. Check the protrusion of the plunger.

      Table 1. Protrusion of the plunger

      Area	Measurement
      a	0.6 to 2.6 mm (0.0236 to 0.102 in.)

      for LHD
      If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary (See pageClick here).

      for RHD
      If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary (See pageClick here).

      Note:

      Do not depress or support the brake pedal.

2. Click here

   INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   (Click here)