PROCEDURE
PRECAUTION (w/ Navigation System)
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.
A Hard Disk Drive (HDD) is built into the multimedia module receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken for the following points when handling the multi-media module receiver assembly.
When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.
CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
REMOVE LUGGAGE TRIM SERVICE HOLE COVER (w/ Navigation System)
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Navigation System)
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH
REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)
REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)
REMOVE NO. 1 RADIO BRACKET (w/o Navigation System)
REMOVE NO. 2 RADIO BRACKET (w/o Navigation System)
REMOVE RADIO RECEIVER ASSEMBLY (HAZARD SWITCH) (w/o Navigation System)
REMOVE NO. 1 RADIO BRACKET (w/ Navigation System)
REMOVE NO. 2 RADIO BRACKET (w/ Navigation System)
REMOVE HARD DISK DRIVE (w/ Navigation System)
REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (HAZARD SWITCH) (w/ Navigation System)