HIGH INTENSITY DISCHARGE HEADLIGHT BULB REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   PRECAUTION

   (Click here)

   Note:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

2. Click here

   REMOVE LUGGAGE TRIM SERVICE HOLE COVER

   Click here

3. Click here

   DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

4. Click here

   REMOVE NO. 1 HEADLIGHT COVER

   CAUTION:

   The headlight light control ECU sub-assembly may be hot when the light control switch is in the HEAD position or right after it is turned off. Check that the headlight light control ECU sub-assembly is not hot before starting work.

   
   
   1. 

      Turn the No. 1 headlight cover in the direction indicated by the arrow shown in the illustration, and remove it.

      Note:
      

      • Do not apply excessive force using a tool.

      • Do not damage the O-ring or allow it to become contaminated with foreign matter. If the O-ring is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction.

5. Click here

   REMOVE DISCHARGE HEADLIGHT BULB

   Click here