AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM ECU Power Source Circuit

DESCRIPTION

This circuit detects the state of the power switch, and sends it to the headlight leveling ECU (headlight swivel ECU assembly).

WIRING DIAGRAM

*1	from IG1 NO. 2 Relay
*2	ECU-IG1 NO. 1
*3	from IG1 NO. 1 Relay
*4	Headlight Leveling ECU (Headlight Swivel ECU Assembly)

CAUTION / NOTICE / HINT

PROCEDURE

1. READ VALUE USING GTS

   
   

   1. Connect the GTS to the DLC3.

   2. Turn the power switch on (IG).

   3. Turn the GTS on.

   4. Enter the following menus: Body Electrical / AFS / Data List.

   5. Read the Data List according to the display on the GTS.

      AFS

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      +B	IG power supply voltage value / 0.00 to 19.75 V	11.00 to 14.00 V	-

      OK
      Normal condition listed above is displayed.

   
   

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

   NG

2. CHECK HARNESS AND CONNECTOR (POWER SOURCE AND BODY GROUND - HEADLIGHT LEVELING ECU (HEADLIGHT SWIVEL ECU ASSEMBLY))

   
   

   1. Disconnect the A80 headlight leveling ECU (headlight swivel ECU assembly) connector.

   2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition A80-14 (IGS) - Body ground Power switch off Below 1 V A80-14 (IGS) - Body ground Power switch on (IG) 11 to 14 V A80-15 (IG) - Body ground Power switch off Below 1 V A80-15 (IG) - Body ground Power switch on (IG) 11 to 14 V

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition A80-22 (E1) - Body ground Always Below 1 Ω

   
   

   OK

   REPLACE HEADLIGHT LEVELING ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) Click here

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR