RAIN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL RAIN SENSOR TAPE

    Tech Tips

    The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.


    1. Clean the rain sensor sensing portion with a piece of cloth.

    2. A01W4TPE01
      Text in Illustration
      *1 Rain Sensor Tape

      Peel off the smaller release sheet, and then attach the rain sensor tape to the rain sensor sensing portion as shown in the illustration.

      Standard Clearance
      Area Measurement
      A 13.5 mm (0.531 in.)
      B 7.25 mm (0.285 in.)

      Tech Tips

      Use your fingers to push out any air bubbles from under the tape.

  2. INSTALL RAIN SENSOR


    1. Clean the windshield glass with a piece of cloth.

      Note


      • Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.

      • If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.

    2. When installing a new rain sensor or when the rain sensor tape has been replaced:


      1. Peel off the release sheet.

        Tech Tips

        Do not touch the silicone coated surfaces.

    3. A01W2S3E01
      Text in Illustration
      *1 Stopper

      Gradually attach the rain sensor to the glass surface to prevent air bubbles from forming between them.

      Tech Tips

      Do not touch the silicone coated or glass surfaces.

    4. Push in the stopper.

    5. Connect the connector.

  3. INSTALL RAIN SENSOR COVER


    1. Engage the 2 claws to install the rain sensor cover.