OUTER MIRROR CONTROL ECU REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (Click here).

2. Click here

   REMOVE LUGGAGE TRIM SERVICE HOLE COVER

   Click here

3. Click here

   DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

4. Click here

   REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

   Click here

5. Click here

   REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

   Click here

6. Click here

   REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

   Click here

7. Click here

   REMOVE DOOR PULL HANDLE COVER

   Click here

8. Click here

   REMOVE COURTESY LIGHT ASSEMBLY

   Click here

9. Click here

   REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

   Click here

10. Click here

    REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

11. Click here

    REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

12. Click here

    REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY

    
    

    1. Disconnect 2 connectors.

    2. 

       Remove the 2 screws and outer mirror control ECU assembly.