OUTER REAR VIEW MIRROR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  5. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  7. REMOVE DOOR PULL HANDLE COVER

    Click here

  8. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  9. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  10. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  11. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

  12. REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY (w/ Memory)

    Click here

  13. REMOVE OUTER MIRROR PROTECTOR


    1. A0004Y3

      Remove the outer mirror protector.

  14. REMOVE OUTER MIRROR INSTALL HOLE COVER


    1. w/o Memory:


      1. A0005AO

        Disconnect the connector.

    2. A0007OK

      Remove the screw.

    3. A0004JPE03

      Disengage the claw<A> as shown in the illustration.

    4. Disengage the claw<B> and remove the outer mirror install hole cover as shown in the illustration.

  15. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


    1. A0004P3

      Remove the 3 nuts.

    2. Disengage the clamp and remove the outer rear view mirror assembly.