Click here

OUTER REAR VIEW MIRROR GLASS REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

Click here

PROCEDURE


  1. Click here

    REMOVE OUTER MIRROR


    1. Push the upper part of the mirror surface and tilt it.

    2. A0004MCE04

      Apply protective tape to the areas shown in the illustration.

      Table 1. Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover

    3. Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror.

    4. Push the upper part of the mirror surface and tilt it.

    5. A0003XZE01

      Apply protective tape to the areas shown in the illustration.

      Table 2. Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover

    6. Using a moulding remover, disengage the 2 claws at the upper part of the outer rear view mirror.

    7. w/o Blind Spot Monitor System:


      1. A0006M8

        Disengage the 2 clamps.

      2. Disconnect the 3 connectors and remove the outer mirror.

    8. w/ Blind Spot Monitor System:


      1. A0005YJ

        Disengage the 3 clamps.

      2. Disconnect the 3 connectors and remove the outer mirror.

      3. Release the tabs of the blind spot monitor indicator connector to disconnect the connector and remove the outer mirror.

        Note:

        • Do not bend the tabs excessively to prevent them from being damaged.

        • If the tabs are damaged, replace the outer mirror with a new one.