LUGGAGE COMPARTMENT DOOR OPENER MAIN SWITCH REMOVAL

Click here

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (Click here).

2. Click here

   REMOVE LUGGAGE TRIM SERVICE HOLE COVER

   Click here

3. Click here

   DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

4. Click here

   REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

5. Click here

   REMOVE FRONT DOOR SCUFF PLATE RH

   Tip:

   Use the same procedure as for the LH side (Click here).

6. Click here

   REMOVE COWL SIDE TRIM BOARD RH

   Tip:

   Use the same procedure as for the LH side (Click here).

7. Click here

   REMOVE FRONT DOOR OPENING TRIM COVER RH

   Tip:

   Use the same procedure as for the LH side (Click here).

8. Click here

   REMOVE INSTRUMENT SIDE PANEL RH

   Click here

9. Click here

   REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

10. Click here

    REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

11. Click here

    REMOVE INSTRUMENT PANEL BOX DOOR COVER

    Click here

12. Click here

    REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

13. Click here

    REMOVE LUGGAGE DOOR OPENING CANCEL SWITCH ASSEMBLY

    
    
    1. 

       Disengage the 2 claws and remove the luggage door opening cancel switch assembly.