LUGGAGE COMPARTMENT DOOR ADJUSTMENT

CAUTION / NOTICE / HINT

A0009N7E01
Text in Illustration
*1 Centering Bolt
*2 Standard Bolt

Tech Tips


  • Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

  • Specified torque for standard bolts is shown in the standard bolt chart Click here.

PROCEDURE


  1. REMOVE LUGGAGE LOCK CONTROL CABLE PLATE

    Click here

  2. REMOVE LUGGAGE COMPARTMENT DOOR INSIDE HANDLE

    Click here

  3. REMOVE LUGGAGE COMPARTMENT DOOR ASSIST GRIP

    Click here

  4. REMOVE LUGGAGE COMPARTMENT DOOR COVER

    Click here

  5. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  6. REMOVE SPARE WHEEL COVER PAD LH

    Click here

  7. REMOVE SPARE WHEEL COVER PAD RH

    Click here

  8. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

  9. REMOVE REAR FLOOR FINISH PLATE

    Click here

  10. ADJUST LUGGAGE COMPARTMENT DOOR


    1. A0007LC

      Loosen the 4 door side hinge bolts to adjust the door horizontally and vertically.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }
    2. A0008CY

      Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.

    3. Using a brass bar and a hammer, hit the striker to adjust its position.

    4. Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustment.

      Torque:
      23 N*m  { 235 kgf*cm, 17 ft.*lbf }

  11. INSTALL REAR FLOOR FINISH PLATE

    Click here

  12. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

  13. INSTALL SPARE WHEEL COVER PAD RH

    Click here

  14. INSTALL SPARE WHEEL COVER PAD LH

    Click here

  15. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  16. INSTALL LUGGAGE COMPARTMENT DOOR COVER

    Click here

  17. INSTALL LUGGAGE COMPARTMENT DOOR ASSIST GRIP

    Click here

  18. INSTALL LUGGAGE COMPARTMENT DOOR INSIDE HANDLE

    Click here

  19. INSTALL LUGGAGE LOCK CONTROL CABLE PLATE

    Click here

  20. INSPECT LUGGAGE COMPARTMENT DOOR


    1. Check that the clearance measurements of areas "a" through "d" are within each standard range.

      A0008YVE01
      Standard Clearance
      Area Measurement Area Measurement
      a 7.0 mm (0.276 in.) b 2.3 to 5.3 mm (0.0906 to 0.209 in.)
      c -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) d 4.0 to 8.0 mm (0.157 to 0.315 in.)