HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL

PROCEDURE

1. REMOVE COOL AIR INTAKE DUCT SEAL

   Click here

2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

   Click here

3. REMOVE FRONT WHEEL LH

4. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

   Tech Tips

   Use the same procedure for the RH side and LH side Click here.

5. REMOVE FRONT FENDER LINER LH

   Tech Tips

   Use the same procedure for the RH side and LH side Click here.

6. REMOVE FRONT DOOR SCUFF PLATE LH

   Click here

7. REMOVE COWL SIDE TRIM BOARD LH

   Click here

8. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

9. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   
   

   1. 

      Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.

10. REMOVE HOOD LOCK ASSEMBLY

    
    

    1. 

       Disconnect the connector.

    2. Disengage the clamp.

    3. 

       Remove the 3 bolts.

    4. 

       Disconnect the hood lock control cable assembly and remove the hood lock assembly.

11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

    
    

    1. Using a screwdriver, disengage 5 clamps and hood cable grommet as shown in the illustration.

       

       Text in Illustration

       *1	Hood Lock Control Cable	*2	Hood Cable Grommet
       *3	Washer Hose	-	-

       Tech Tips

       Tape the screwdriver tip before use.

    2. Pull the hood lock control cable assembly from the engine compartment and remove it.