Click here

HOOD SUPPORT INSTALLATION

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

Click here

PROCEDURE


  1. Click here

    INSTALL HOOD SUPPORT ASSEMBLY

    Note:

    • Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

    • Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

    • In order to prevent the piston rod from deforming, do not apply any horizontal load to the door stay.


    1. When reusing the hood support assembly:


      1. A01W0XE

        Install the 2 stop rings to the hood support assembly.

    2. A01W0V0

      Install the hood support assembly.

      Note:

      Install the hood support assembly while supporting the hood by hand.

    3. Check that the hood support assembly is engaged in the ball joint and it cannot be pulled out.