SLIDING ROOF SWITCH ASSEMBLY INSPECTION

PROCEDURE

1. Click here

   INSPECT SLIDING ROOF SWITCH (ROOF CONSOLE BOX ASSEMBLY)

   
   
   1. 

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition 23 (UP) - 19 (GND) UP switch is pressed Below 1 Ω 23 (UP) - 19 (GND) UP switch is not pressed 10 kΩ or higher 24 (DOWN) - 19 (GND) DOWN switch is pressed Below 1 Ω 24 (DOWN) - 19 (GND) DOWN switch is not pressed 10 kΩ or higher 11 (OPN) - 19 (GND) OPEN switch is pressed Below 1 Ω 11 (OPN) - 19 (GND) OPEN switch is not pressed 10 kΩ or higher 12 (CLS) - 19 (GND) CLOSE switch is pressed Below 1 Ω 12 (CLS) - 19 (GND) CLOSE switch is not pressed 10 kΩ or higher

      Table 1. Text in Illustration

      *a	Component without harness connected (Sliding Roof Switch (Roof Console Box Assembly))

      If the result is not as specified, replace the sliding roof switch (roof console box assembly).