SLIDING ROOF HOUSING REASSEMBLY

PROCEDURE


  1. INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    1. A0006LOE04
      Text in Illustration
      *1 Guide
      *2 Spring

      Engage the 2 guides in the direction indicated by the arrow (1) in the illustration to install the roof wind deflector panel sub-assembly.

    2. Engage the 2 springs in the direction indicated by the arrow (2) in the illustration.

      Note

      Make sure that the springs are securely installed.

  2. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


    1. A00065T

      Hold down the roof wind deflector panel sub-assembly.

    2. A0007XME01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the other sliding roof drive cable sub-assembly.

  3. INSTALL REAR ROOF DRIP CHANNEL


    1. A0009MRE04

      Insert the rear roof drip channel in the direction indicated by the arrow (1) in the illustration.

    2. Engage the 2 claws in the direction indicated by the arrow (2) in the illustration to install the rear roof drip channel.

  4. ADJUST FULLY CLOSED POSITION


    1. A000457E04
      Text in Illustration
      *1 Alignment Mark

      Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction indicated by the arrows in the illustration and alignment marks.

      Tech Tips

      Tape the screwdriver tip before use.

  5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    1. A0007OP

      Insert the sunshade trim sub-assembly into the sliding roof housing sub-assembly.

    2. A0004QJ

      Install the sliding roof piece sub-assembly LH with the screw.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }

      Tech Tips

      Use the same procedure for the RH side.

  6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A0007TT

      Install the sliding roof drive gear sub-assembly with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    2. A0004IME07
      Text in Illustration
      *1 Guide
      *2 Pin

      Engage the guide and pin.

    3. Engage the claw and install the map light bracket.