SLIDING ROOF HOUSING DISASSEMBLY

PROCEDURE


  1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A0004IME06
      Text in Illustration
      *1 Guide
      *2 Pin

      Disengage the claw.

    2. Disengage the guide and pin, and remove the map light bracket.

    3. A0007TT

      Remove the 2 bolts and sliding roof drive gear sub-assembly.

  2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY


    1. A0004QJ

      Remove the screw and the sliding roof piece sub-assembly LH.

      Tech Tips

      Use the same procedure for the RH side.

    2. A0005B6

      Slide and remove the sunshade trim sub-assembly.

  3. REMOVE REAR ROOF DRIP CHANNEL


    1. A00046SE04
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, disengage the 2 claws in the direction indicated by the arrow (1) in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    2. Then slide the rear roof drip channel in the direction indicated by the arrow (2) in the illustration to remove it.

  4. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

    Note

    Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


    1. A00065T

      Hold down the roof wind deflector panel sub-assembly.

    2. A0007WVE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the other sliding roof drive cable sub-assembly.

  5. REMOVE ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    1. A0007FGE04
      Text in Illustration
      *1 Spring
      *2 Guide

      Pull the spring in the direction indicated by the arrow (1) in the illustration to disengage the 2 springs.

    2. Pull the roof wind deflector panel sub-assembly in the direction indicated by the arrow (2) in the illustration to disengage the 2 guides and remove it.