Click here

SLIDING ROOF SYSTEM, Diagnostic DTC:B2343

Click here
Click here
DTC Code DTC Name
B2343 Position Initialization Incomplete
Click here

DESCRIPTION

This DTC is stored when the sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized.

DTC No. DTC Detection Condition Trouble Area
B2343 Sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized. Sliding roof ECU (Sliding roof drive gear sub-assembly)
Click here

WIRING DIAGRAM

Refer to DTC B2341 (Click here).

Click here

CAUTION / NOTICE / HINT

Note:

  • When DTC B2342 and B2343 are output simultaneously, perform troubleshooting for DTC B2342 first.

  • When the sliding roof ECU (sliding roof drive gear sub-assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear sub-assembly) must be initialized (Click here).

  • The sliding roof system uses the CAN and LIN communication systems. First, confirm that there are no malfunctions in the CAN and LIN communication systems. Refer to How to Proceed with Troubleshooting (Click here).

Click here

PROCEDURE


  1. Click here

    INITIALIZE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)


    1. Check that the sliding roof ECU (sliding roof drive gear sub-assembly) can be initialized (Click here).

      OK
      Sliding roof ECU (sliding roof drive gear sub-assembly) can be initialized.

  2. Click here

    CHECK SLIDING ROOF OPERATION


    1. Check the sliding roof auto operation (Click here).

      OK
      Auto operation operates normally.

  3. Click here

    CHECK DTC OUTPUT


    1. Clear the DTCs (Click here).

    2. Recheck for DTCs.

      OK
      DTC B2343 is not output.

    • OK

      END (PROBLEM DUE TO INITIALIZATION FAILURE)

    • NG

      REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (Click here)