POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (Click here).

2. Click here

   INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

   Click here

3. Click here

   INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

   Click here

4. Click here

   INSTALL REAR DOOR GLASS ASSEMBLY

   Click here

5. Click here

   INSTALL REAR DOOR QUARTER WINDOW GLASS

   
   
   1. 

      Install the rear door quarter window glass with the rear door quarter window weatherstrip as shown in the illustration.

6. Click here

   INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

   Click here

7. Click here

   INSTALL REAR DOOR GLASS RUN

   Click here

8. Click here

   CONNECT REAR DOOR WEATHERSTRIP

   
   
   1. 

      Install the upper part of rear door weatherstrip as shown in the illustration.

9. Click here

   INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

10. Click here

    INSTALL REAR DOOR ARMREST SET BRACKET

    Click here

11. Click here

    INSTALL REAR SPEAKER ASSEMBLY

    Click here

12. Click here

    INSTALL REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

    Click here

13. Click here

    INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

14. Click here

    INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

15. Click here

    INSTALL COURTESY LIGHT ASSEMBLY

    Click here

16. Click here

    INSTALL REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

17. Click here

    INSTALL DOOR PULL HANDLE COVER

    Click here

18. Click here

    INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

19. Click here

    INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

20. Click here

    CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

21. Click here

    INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

22. Click here

    INITIALIZE POWER WINDOW CONTROL SYSTEM

    (Click here)

23. Click here

    INSPECT POWER WINDOW OPERATION

    (Click here)