POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.

PROCEDURE

PRECAUTION

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.
INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

Click here
INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

Click here
INSTALL REAR DOOR GLASS ASSEMBLY

Click here
INSTALL REAR DOOR QUARTER WINDOW GLASS
1. Install the rear door quarter window glass with the rear door quarter window weatherstrip as shown in the illustration.
INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

Click here
INSTALL REAR DOOR GLASS RUN

Click here
CONNECT REAR DOOR WEATHERSTRIP
1. Install the upper part of rear door weatherstrip as shown in the illustration.
INSTALL REAR DOOR SERVICE HOLE COVER

Click here
INSTALL REAR DOOR ARMREST SET BRACKET

Click here
INSTALL REAR SPEAKER ASSEMBLY

Click here
INSTALL REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

Click here
INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

Click here
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Click here
INSTALL COURTESY LIGHT ASSEMBLY

Click here
INSTALL REAR DOOR NO. 1 STIFFENER CUSHION

Click here
INSTALL DOOR PULL HANDLE COVER

Click here
INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Click here
INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Click here
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL LUGGAGE TRIM SERVICE HOLE COVER

Click here
INITIALIZE POWER WINDOW CONTROL SYSTEM

Click here
INSPECT POWER WINDOW OPERATION

Click here