FRONT PASSENGER SIDE POWER WINDOW SWITCH INSPECTION

PROCEDURE

1. Click here

   INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY

   
   
   1. 

      Check the switch function.

      
      

      1. Measure the resistance according to the value(s) in the table below.

         Standard Resistance
         Tester Connection Condition Specified Condition 6 (UP) - 1 (GND) Auto up or up position Below 1 Ω 7 (DOWN) - 1 (GND) Auto down or down position Below 1 Ω 8 (AUTO) - 1 (GND) Auto up or auto down position Below 1 Ω 6 (UP) - 1 (GND) Free 10 kΩ or higher 7 (DOWN) - 1 (GND) Free 10 kΩ or higher 8 (AUTO) - 1 (GND) Free 10 kΩ or higher

         Table 1. Text in Illustration

         *a	Component without harness connected (Power Window Regulator Switch Assembly)

         If the result is not as specified, replace the power window regulator switch assembly.

   2. 

      Check that the LED illuminates.

      
      

      1. Apply auxiliary battery voltage to the power window regulator switch assembly and check that the LED illuminates.

         OK
         Measurement Condition Specified Condition Auxiliary battery positive (+) → 4 (LED) Auxiliary battery negative (-) → 1 (GND) LED illuminates

         Table 2. Text in Illustration

         *a	Component without harness connected (Power Window Regulator Switch Assembly)
         *b	LED

         If the result is not as specified, replace the power window regulator switch assembly.