SIDE AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL SIDE AIRBAG SENSOR ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

      Table 1. Text in Illustration

      *a

      Correct

      *b

      Incorrect

   4. Insert the pin (stopper) into the body hole and install the side airbag sensor assembly to the vehicle body with the nut.

      9.0 N*m

      92 kgf*cm

      80 in.*lbf

      Note:
      

      • If the side airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the side airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the pin (stopper) is securely inserted into the body hole.

      • Tighten the nut while holding the side airbag sensor assembly because the side airbag sensor assembly pin (stopper) is easily damaged.

   5. Connect the connector to the side airbag sensor assembly.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      
      
      1. 

         Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).

         Table 2. Text in Illustration

         *1	White housing lock	-	-
         *a	Slide	-	-

         Tip:

         When engaged, the white housing lock will slide. Be sure not to hold the white housing lock and part (A), as it may result in an insecure fit.

   6. Check that there is no looseness in the installed parts of the side airbag sensor assembly.

2. Click here

   INSTALL CENTER PILLAR LOWER GARNISH

   Click here

3. Click here

   INSTALL REAR DOOR SCUFF PLATE

   Click here

4. Click here

   INSTALL FRONT DOOR SCUFF PLATE

   Click here

5. Click here

   CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

6. Click here

   INSTALL LUGGAGE TRIM SERVICE HOLE COVER

   Click here

7. Click here

   PERFORM DIAGNOSTIC SYSTEM CHECK

   (Click here)

8. Click here

   INSPECT SRS WARNING LIGHT

   (Click here)