CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL AIRBAG SENSOR ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A0004LPE04
      Text in Illustration
      *a Fulcrum Length

      Using SST, install the airbag sensor assembly with the 3 bolts.

      SST
      09961-00950
      Torque:
      without SST
      18 N*m  { 178 kgf*cm, 13 ft.*lbf }
      with SST
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Note


      • Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

      • This torque value is effective when SST is parallel to a torque wrench.

      • If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • When the power switch is first turned on (IG) after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

    4. A0008CGE04
      Text in Illustration
      *1 Waterproof Sheet

      Connect the connectors to the airbag sensor assembly as shown in the illustration.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    5. Check that the waterproof sheet is properly set.

    6. Check that there is no looseness in the installed parts of the airbag sensor assembly.

  2. INSTALL NO. 1 CONSOLE BOX DUCT

    Click here

  3. INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET

    Click here

  4. INSTALL FLOOR CARPET BRACKET LH

    Click here

  5. INSTALL FLOOR CARPET BRACKET RH

    Click here

  6. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here

  7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  10. INSPECT SRS WARNING LIGHT

    Click here

  11. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

    Tech Tips


    • When the airbag sensor assembly is replaced, perform zero point learning for the yaw rate and acceleration sensor Click here.

    • The yaw rate and acceleration sensor is built into the airbag sensor assembly.