CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

PROCEDURE

1. Click here

   INSTALL AIRBAG SENSOR ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      Using SST, install the airbag sensor assembly with the 3 bolts.

      09961-00950

      Table 1. Text in Illustration

      *a	Fulcrum Length

      without SST
      18 N*m	178 kgf*cm	13 ft.*lbf
      with SST
      11 N*m	112 kgf*cm	8 ft.*lbf

      Note:
      

      • Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

      • This torque value is effective when SST is parallel to a torque wrench.

      • If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • When the power switch is first turned on (IG) after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

   4. 

      Connect the connectors to the airbag sensor assembly as shown in the illustration.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

   5. Check that the waterproof sheet is properly set.

      Table 2. Text in Illustration

      *1	Waterproof Sheet

   6. Check that there is no looseness in the installed parts of the airbag sensor assembly.

2. Click here

   INSTALL NO. 1 CONSOLE BOX DUCT

   Click here

3. Click here

   INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET

   Click here

4. Click here

   INSTALL FLOOR CARPET BRACKET LH

   Click here

5. Click here

   INSTALL FLOOR CARPET BRACKET RH

   Click here

6. Click here

   INSTALL REAR CONSOLE BOX ASSEMBLY

   (Click here)

7. Click here

   CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

8. Click here

   INSTALL LUGGAGE TRIM SERVICE HOLE COVER

   Click here

9. Click here

   PERFORM DIAGNOSTIC SYSTEM CHECK

   (Click here)

10. Click here

    INSPECT SRS WARNING LIGHT

    (Click here)

11. Click here

    PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

    Tip:
    

    • When the airbag sensor assembly is replaced, perform zero point learning for the yaw rate and acceleration sensor (Click here).

    • The yaw rate and acceleration sensor is built into the airbag sensor assembly.