CENTER AIRBAG SENSOR ASSEMBLY REMOVAL

Click here Click here

PROCEDURE

1. Click here

   PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing (Click here).

   Note:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

2. Click here

   REMOVE LUGGAGE TRIM SERVICE HOLE COVER

   Click here

3. Click here

   DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

4. Click here

   REMOVE REAR CONSOLE BOX ASSEMBLY

   (Click here)

5. Click here

   REMOVE FLOOR CARPET BRACKET LH

   Click here

6. Click here

   REMOVE FLOOR CARPET BRACKET RH

   Click here

7. Click here

   REMOVE NO. 1 CONSOLE BOX MOUNTING BRACKET

   Click here

8. Click here

   REMOVE NO. 1 CONSOLE BOX DUCT

   Click here

9. Click here

   REMOVE AIRBAG SENSOR ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. Turn back the carpet.

   4. 

      Disconnect the connectors from the airbag sensor assembly as shown in the illustration.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

   5. Remove the 3 bolts and airbag sensor assembly.