REAR SEAT SIDE AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL REAR SEAT AIRBAG ASSEMBLY

   CAUTION:
   
   

   • The nuts must not be reused.

   • Make sure that the bench type rear seatback pad is not deformed. If it is, replace it with a new one.

   
   

   1. Install the rear seat airbag assembly with 4 new nuts.

      5.5 N*m

      56 kgf*cm

      49 in.*lbf

   2. 

      Using hog ring pliers, install 3 new hog rings.

      Table 1. Text in Illustration

      *1	Hog Ring
      *2	Clamp
      *3	Fastener

      Note:
      

      • Be careful not to damage the bench type rear seatback cover.

      • Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the bench type rear seatback cover.

   3. Engage the clamp and the fastener to secure the airbag wire harness.

2. Click here

   INSTALL REAR SEATBACK ASSEMBLY

   Click here

3. Click here

   INSTALL REAR SEAT CUSHION ASSEMBLY

   Click here

4. Click here

   INSTALL REAR CENTER SEAT HEADREST ASSEMBLY

5. Click here

   INSTALL REAR SEAT HEADREST ASSEMBLY

6. Click here

   CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

7. Click here

   INSTALL LUGGAGE TRIM SERVICE HOLE COVER

   Click here

8. Click here

   PERFORM DIAGNOSTIC SYSTEM CHECK

   (Click here)

9. Click here

   INSPECT SRS WARNING LIGHT

   (Click here)