Click here

REAR SEAT SIDE AIRBAG ASSEMBLY REMOVAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

CAUTION:

If the rear seat airbag assembly was deployed, replace the rear seat airbag assembly, bench type rear seatback cover and bench type rear seatback pad with the necessary parts in accordance with the extent of the collision damage (Click here).

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing (Click here).

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

  2. Click here

    REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. Click here

    DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  4. Click here

    REMOVE REAR SEAT HEADREST ASSEMBLY

  5. Click here

    REMOVE REAR CENTER SEAT HEADREST ASSEMBLY

  6. Click here

    REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  7. Click here

    REMOVE REAR SEATBACK ASSEMBLY

    Click here

  8. Click here

    REMOVE REAR SEAT AIRBAG ASSEMBLY

    CAUTION:

    When storing the rear seat airbag assembly, keep the airbag deployment side facing upward.


    1. A0006QQE01

      Remove the 3 hog rings.

      Table 1. Text in Illustration
      *1 Hog Ring
      *2 Clamp
      *3 Fastener

    2. Disengage the clamp and fastener to disconnect the airbag wire harness.

    3. A0007QC

      Remove the 4 nuts and rear seat airbag assembly.

      CAUTION:

      • The nuts must not be reused.

      • Make sure that the bench type rear seatback pad is not deformed. If it is, replace it with a new one.