FRONT PASSENGER AIRBAG ASSEMBLY REMOVAL

Click here Click here

PROCEDURE

1. Click here

   PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing (Click here).

   Note:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

2. Click here

   REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

   (Click here)

3. Click here

   DISCONNECT NO. 2 INSTRUMENT PANEL WIRE

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      Slide the slider to release the lock, and then disconnect the connector.

      Table 1. Text in Illustration

      *1

      Slider

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

4. Click here

   REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

   Click here

5. Click here

   REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

   CAUTION:

   When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.

   
   
   1. 

      Remove the 2 screws and disengage the 2 clamps.

   2. 

      Lean the instrument panel safety pad assembly and disengage the 3 hooks.

   3. 

      Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the instrument panel safety pad assembly.

6. Click here

   REMOVE NO. 2 INSTRUMENT PANEL WIRE

   
   
   1. 

      Disengage the clamp.

   2. Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.

      Table 2. Text in Illustration

      *1	Protective Tape
      *2	Airbag Connector
      *3	Airbag Connector Lock

   3. Disconnect the 2 airbag connectors to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.