KNEE AIRBAG ASSEMBLY(for Front Passenger Side) INSTALLATION

PROCEDURE


  1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A0009KQE04
      Text in Illustration
      *1 Airbag Connector Lock
      *2 Airbag Connector

      Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    4. Push in the airbag connector lock to install the airbag connector.

    5. Engage the 5 claws and 2 guides to temporarily install the lower No. 2 instrument panel airbag assembly.

    6. Install the 3 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

  2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  3. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  4. INSTALL FRONT DOOR OPENING TRIM COVER RH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  5. INSTALL COWL SIDE TRIM BOARD RH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  6. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  10. INSPECT SRS WARNING LIGHT

    Click here