CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

Info Added 2017-08-02

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A0004E4E02
      Text in Illustration
      *1 New Tape

      Apply 2 new tapes to install the rear No. 2 side rail spacer to the curtain shield airbag assembly as shown in the illustration.

    4. A0004D4E02
      Text in Illustration
      *1 Airbag Connector
      *2 Airbag Connector Lock

      Connect the airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    5. Push in the airbag connector lock to install the curtain shield airbag connector.

    6. Engage the 2 clamps and 4 hooks to temporarily install the curtain shield airbag assembly.

      A0005KZE02
      Text in Illustration
      *1 Clamp *2 Hook

      Note


      • When installing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.

      • Do not twist the curtain shield airbag assembly when installing it.

    7. Engage the 2 clamps and clip.

      A0004GP

    8. Install 5 new clips.

      Text in Illustration
      A0005GR New Bolt A0009JS New Clip

    9. Install 4 new bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }
    10. A0004IA

      Push in 5 new pins to each clip.

      Note

      Make sure that the pins of the clips are pushed in firmly.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here