STEERING PAD INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL HORN BUTTON ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      Engage the wire harness clamp.

      Table 1. Text in Illustration

      *a	Airbag Connector
      *b	Horn Connector
      *c	Airbag Connector Lock
      *d	Wire Harness Clamp

   4. Connect the 2 airbag connectors to the horn button assembly.

      Note:
      

      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to only connect the connectors to each corresponding color.

   5. Push in the 2 airbag connector locks to install the 2 airbag connectors.

   6. Connect the horn connector to the horn button assembly.

   7. 

      Push the horn button assembly to engage the 3 pins carefully and install the horn button assembly.

      Note:
      

      • Make sure that the pins are securely inserted into the steering wheel assembly holes.

      • Make sure to engage the 2 upper pins first.

      • Make sure that the horn button assembly is securely installed.

2. Click here

   INSTALL LOWER NO. 3 STEERING WHEEL COVER

   
   
   1. 

      Engage the claw and guide to install the lower No. 3 steering wheel cover.

3. Click here

   INSTALL LOWER NO. 2 STEERING WHEEL COVER

   
   
   1. 

      Engage the claw and guide to install the lower No. 2 steering wheel cover.

4. Click here

   CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

5. Click here

   INSTALL LUGGAGE TRIM SERVICE HOLE COVER

   Click here

6. Click here

   INSPECT HORN BUTTON ASSEMBLY

   
   

   1. Make sure that the horn sounds.

      If the horn does not sound, inspect the horn system (Click here).

7. Click here

   PERFORM DIAGNOSTIC SYSTEM CHECK

   (Click here)

8. Click here

   INSPECT SRS WARNING LIGHT

   (Click here)