AIRBAG SYSTEM DATA LIST / ACTIVE TEST

Tech Tips

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

Note

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


  1. DATA LIST FOR AIRBAG SENSOR ASSEMBLY


    1. Turn the power switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / SRS Airbag / Data List.

    6. Check the values by referring to the table below.

      SRS Airbag
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Driver Seat Position

      Driver Seat Position/

      Forward: Seat position is forward

      Bkward: Seat position is backward

      Fail: Failure detected

      Forward/Bkward -
      Left side Buckle SW

      LH Side Buckle SW/

      Unset: The seat belt is not fastened

      Set: The seat belt is fastened

      NG: Data is not determined

      Unset/Set -
      Display Type Information

      Display Type Information/

      LR: The display is indicated by LH/RH

      DP: The display is indicated by Driver/Passenger

      LR -
      Number of Past DTC

      Number of Past DTC/

      Min.: 0, Max.: 255

      0 -