COMBINATION METER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Disable the auto away/return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the auto away/return function is enabled or disabled) in order to restore the current setting after finishing this operation.

      Tech Tips

      Performing the above operation disables the auto away/return function when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the power switch off and disconnect the cable from the auxiliary battery negative (-) terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A0003O0

      Using a moulding remover, disengage the 4 clips and 2 guides.

    2. A0006JI

      Remove the 2 screws.

    3. A0006LF

      Disengage the 5 claws and 2 guides.

    4. Disconnect the connector and remove the instrument cluster finish panel sub-assembly.

  5. REMOVE COMBINATION METER ASSEMBLY


    1. A000403

      Remove the 2 screws.

    2. A0006TW

      Disengage the 2 clips.

    3. Disconnect the 2 connectors to remove the combination meter assembly.