Click here

METER / GAUGE SYSTEM Hybrid System Indicator Malfunction

Click here
Click here
DTC Code DTC Name
  Hybrid System Indicator Malfunction
Click here

DESCRIPTION

A hybrid system indicator is adopted for this vehicle. In this circuit, the combination meter assembly receives the hybrid system indicator level signal from the hybrid vehicle control ECU assembly via CAN communication. The combination meter assembly controls the operation of the hybrid system indicator according to the hybrid system indicator level signal received from the hybrid vehicle control ECU assembly via CAN communication.

Table 1. *1 Hybrid Vehicle Control ECU Assembly *2 Combination Meter Assembly *3 CAN Communication Line
Click here

WIRING DIAGRAM

Click here

PROCEDURE


  1. Click here

    CHECK CAN COMMUNICATION SYSTEM


    1. Check if CAN communication DTCs are output (See page w/ Central Gateway ECU,Click herew/o Central Gateway ECU).

      Result
      Result Proceed to
      CAN communication DTCs are not output. A
      CAN communication DTCs are output (w/ Central Gateway ECU). B
      CAN communication DTCs are output (w/o Central Gateway ECU). C

  2. Click here

    PERFORM ACTIVE TEST USING GTS (HV SYSTEM INDICATOR)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. B0011F5E01

      Perform the Active Test according to the display on the GTS.

      Table 2. Text in Illustration
      *a MIN
      *b -50%
      *c 0%
      *d 100%
      *e 200%
      *f 300%
      *g 400%
      *h MAX
      Table 3. Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      HV System Indicator Hybrid system indicator OFF, MIN, -50%, 0%, 100%, 200%, 300%, 400%, MAX -
      OK
      Hybrid system indicator indication is normal.

  3. Click here

    READ VALUE USING GTS (HYBRID SYSTEM INDICATOR)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Data Test.

    5. Read the Data List according to the display on the GTS.

      Table 4. Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Hybrid System Indicator Hybrid system indicator value/ Min.: -512%, Max.: 511% -512 to 511% -
      OK
      Hybrid system indicator value displayed on the GTS is almost the same as hybrid system indicator indication.

  4. Click here

    REPLACE COMBINATION METER ASSEMBLY


    1. Replace the combination meter assembly with a new one (Click here).

      OK
      The operation of the hybrid system indicator returns to normal.

    • OK

      END

    • NG

      REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY (Click here)