Click here

METER / GAUGE SYSTEM DATA LIST / ACTIVE TEST

Click here
Click here
Click here
  1. DATA LIST

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Warm up the engine.

    2. Turn the power switch off.

    3. Connect the GTS to the DLC3.

    4. Turn the power switch on (IG).

    5. Turn the GTS on.

    6. Enter the following menus:


      1. for Combination Meter: Body Electrical / Combination Meter / Data List.

      2. for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.

      3. for Hybrid Control: Powertrain / Hybrid Control / Data List.

      4. for Engine and ECT: Powertrain / Engine and ECT / Data List.

      5. for Main Body: Body Electrical / Main Body / Data List.

    7. Check the values by referring to the table below.

      Table 1. Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Tail Relay SW Tail relay/OFF or ON OFF: Tail relay off -
      ON: Tail relay on
      ODO/TRIP Change SW ODO/TRIP switch/OFF or ON OFF: Switch released -
      ON: Switch pushed -
      P-Seatbelt Buckle SW Front passenger seat belt buckle switch/OFF or ON OFF: Front passenger seat belt fastened (warning light off) -
      ON: Front passenger seat belt unfastened (warning light on)
      Vehicle Speed Meter Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -
      Engine Rpm Engine speed/Min.: 0 rpm, Max.: 12750 rpm Approximately 900 rpm: Idling -
      Coolant Temperature Engine coolant temperature/0 to 127.5°C (0 to 261.5°F) After warming up: 75 to 100°C (167 to 212°F) -
      Washer Switch Washer fluid level warning switch/OFF or ON OFF: Washer fluid level not low -
      ON: Washer fluid level low -
      Check Engine SW MIL (Check engine warning light/OFF or ON OFF: MIL (Check engine warning light) off -
      ON: MIL (Check engine warning light) on -
      Light Control Up Switch Light control rheostat up switch/OFF or ON OFF: Light control rheostat up switch not pressed -
      ON: Light control rheostat up switch pressed
      Light Control Down Switch Light control rheostat down switch/OFF or ON OFF: Light control rheostat down switch not pressed -
      ON: Light control rheostat down switch pressed
      Multi Display Select Switch DISP switch/OFF or ON OFF: DISP switch not pressed -
      ON: DISP switch pressed
      +B Voltage Value Auxiliary battery voltage/Min.: 0 V, Max.: 25.5 V 11 to 14 V -
      Fuel Input Fuel input/Min.: 0 L, Max.: 127.5 L Fuel receiver gauge indicates F: 58.5 L -
      Fuel receiver gauge indicates 3/4: 48.8 L
      Fuel receiver gauge indicates 1/2: 32.5 L
      Fuel receiver gauge indicates 1/4: 16.3 L
      Fuel receiver gauge indicates E: 6.5 L
      Ambient Temperature Outside temperature/Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) Almost the same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
      HV System Indicator

      Hybrid system indicator value/

      Min.: -512 %, Max. 511 %

      -512 to 511 % -
      Oil Pressure Switch Oil pressure switch/OFF or ON OFF: Engine started -
      ON: Engine not started
      Turn Signal Switch (Right) RH turn signal switch/OFF or ON OFF: RH turn signal switch off -
      ON: RH turn signal switch on
      Turn Signal Switch (Left) LH turn signal switch/OFF or ON OFF: LH turn signal switch off -
      ON: LH turn signal switch on
      Hazard Flasher Switch Hazard warning switch/OFF or ON OFF: Hazard warning switch off -
      ON: Hazard warning switch on
      Headlight Auto Leveling Switch Headlight leveling warning light/OFF or ON OFF: Headlight leveling warning light off -
      ON: Headlight leveling warning light on
      Turn Switch Signal (Full Turn) Turn signal switch/OFF or ON OFF: LH or RH turn signal switch off -
      ON: LH or RH turn signal switch on
      Driver Side Seatbelt Warning Buzzer Condition of the driver seat belt warning buzzer/OFF or ON OFF: The seat belt warning buzzer does not sound at a vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened Displays customize setting of Driver Side Seat Belt Warning Buzzer
      ON: The seat belt warning buzzer sounds at a vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened
      P-Seatbelt Warning Buzzer Condition of the front passenger seat belt warning buzzer/OFF or ON OFF: The seat belt warning buzzer does not sound at a vehicle speed of 20 km/h (12 mph) or more when the front passenger seat belt unfastened Displays customize setting of Front Passenger Side Seat Belt Warning Buzzer
      ON: The seat belt warning buzzer sounds at a vehicle speed of 20 km/h (12 mph) or more when the front passenger seat belt unfastened
      ODO Display Time After IG OFF Setting Condition of the ODO display time after power switch off/30s, 60s, 600s, OFF 30s, 60s, 600s, OFF Displays customize setting of ODO Display Time After IG OFF Setting
      Lane Change Flashing Times Setting Condition of the lane change flashing times/OFF, 3, 5, 7 OFF, 3, 5, 7 Displays customize setting of Lane Change Flashing Times Setting
      Flasher Sound Volume Adjustment Condition of the flasher sound volume/Large, Medium, Small Large, Medium, Small Displays customize setting of Flasher Sound Volume Adjustment
      Number of Trouble Code The number of the DTC currently stored/Min.: 0, Max.: 255 0 -
      Table 2. ABS/VSC/TRC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Vehicle Speed Maximum wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
      Table 3. Hybrid Control
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Engine Revolution

      Engine speed/

      Min.: 0 rpm, Max.: 16383 rpm

      While idling after the engine is warmed up and inspection mode:

      Approximately 900 rpm

      While driving at a constant speed:

      No significant fluctuation

      -
      Table 4. Engine and ECT
      Tester Display Measurement Item/Range Normal Condition Stored as Freeze Frame Data
      Coolant Temp

      Coolant temperature/

      Min.: -40°C (-40°F), Max.: 140°C (284°F)

      75 to 100°C (167 to 212°F): After warming up Yes

      Diagnostic Note:

      This is the engine coolant temperature.

      Tip:
      • After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).

      • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.

      • If the value is -40°C (-40°F), or higher than 140°C (284°F), the sensor circuit is open or shorted.

      • Check if the engine overheats when the value indicates 140°C (284°F).

      Tip:

      Enter maintenance mode (Click here).

      Table 5. Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Illumination Rate Info Illumination rate information/0.00 ms. to 2162.65 ms. Value is output according to ambient light level -
  2. ACTIVE TEST

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Check the operation by referring to the table below.

      Table 6. Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer OFF, 0, 40, 80, 120, 160, 200, 240 km/h -
      Tacho Meter Operation Tachometer OFF, 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 -
      Fuel Meter Operation Fuel receiver gauge OFF, Empty, 1/2, Full -
      A/T Indicator Operation 1 Shift indicator OFF, L, 2, 3(M), 4(M), D, N, R, P -
      A/T Indicator Operation 2 Shift indicator OFF, 5, 6, Es -
      Indicat. Lamp Airbag SRS warning light OFF or ON -
      Indicat. Lamp Doors All Open Door warning light OFF or ON -
      Driver Side Seat Belt Driver/front passenger seat belt warning light OFF or ON -
      Indicat. Lamp ABS ABS warning light OFF or ON -
      Indicat. Lamp Charge Charge warning light OFF or ON -
      Indicat. Lamp Slip Slip indicator light OFF or ON -
      Indicat. Lamp Beam High beam indicator light OFF or ON -
      Indicat. Lamp Tail Tail indicator light OFF or ON -
      Indicat. Lamp Fr FOG Front fog indicator light OFF or ON -
      Indicat. Lamp Rr FOG Rear fog indicator light OFF or ON -
      Indicat. Precrash*1 PCS warning light OFF or ON -
      Indicat. Headlamp Auto Leveling Headlight leveling warning light OFF or ON -
      Indicat. Lamp Fuel Fuel level warning light OFF or ON -
      Indicat. Tire Pressure Warning System Tire pressure warning light OFF or ON -
      Indicat. Lamp ECB Electrically controlled brake warning light OFF or ON -
      Indicat. TEMS Sports Ambient illumination (SPORT lamp) OFF or ON -
      Indicat. Lamp Cruise Cruise main indicator light OFF or ON -
      Indicat. Lamp Brake Brake warning light OFF or ON -
      Indicat. EPS EPS warning light OFF or ON -
      Master Warning Master warning light OFF or ON -
      Indicat. Clearance Sonar LCD Clearance sonar indicator light OFF or ON -
      Indicat. Ready (HV) Ready indicator light OFF or ON -
      Indicat. SET Cruise SET indicator light OFF or ON -
      Indicat. Radar Cruise*2 Radar cruise main indicator light OFF or ON -
      Indicat. VSC OFF VSC OFF indicator light OFF or ON -
      Automatic High Beam Indicator*3 Automatic high beam indicator light OFF or ON -
      EV Mode Indicator EV indicator light OFF or ON -
      Turn Signal (Left) Indicator LH turn indicator light OFF or ON -
      Turn Signal (Right) Indicator RH turn indicator light OFF or ON -
      Check Engine Indicator MIL (Check engine warning light) OFF or ON -
      LDA Control Indicator*4 LDA warning light OFF or ON -
      Water Temperature Meter Operation Engine coolant temperature receiver gauge OFF, LOW, NORMAL, HIGH -
      HV System Indicator Hybrid system indicator OFF, MIN, -50%, 0%, 100%, 200%, 300%, 400%, MAX -
      Meter Display 1 Multi-information display OFF, All -

      • *1: w/ Pre-crash safety system

      • *2: w/ Dynamic radar cruise control system

      • *3: w/ Automatic high beam system

      • *4: w/ Lane departure alert system