Note
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| Parking Assist Monitor System (w/ Parallel Parking Assist Function) | |
| Parking Assist Monitor System (w/o Parallel Parking Assist Function) | |
| Power Trunk Lid System |
WARNING NOTIFICATION FUNCTION (w/ Telematics System)
Note
Before performing inspections or repairs which may cause warning messages or DTCs to occur, such as a simulation test or road test, it is necessary to activate warning notification restraint mode so that the G-BOOK center does not recognize the warnings as real ones.
Warning notification restraint mode can be entered by using the GTS or operating the remote touch.
Tech Tips
The warning notification function sends a warning on signal, received from the combination meter assembly via CAN communication, to the G-BOOK center using the telematics transceiver if a warning is displayed in the vehicle due to a vehicle malfunction.
Warning notification restraint mode
Tech Tips
To cancel warning notification restraint mode, turn the power switch off and on (IG) to display the service mode screen and cancel warning notification restraint mode.
Warning notification restraint mode (Using the GTS)
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (READY).
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Warning notification restraint mode (Using the remote touch)
Enter diagnostic mode of navigation system Click here.
PRECAUTION WHEN REPLACING COMBINATION METER ASSEMBLY
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.