When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| Parking Assist Monitor System | |
| Power Trunk Lid System |
WARNING NOTIFICATION FUNCTION (w/ G-BOOK SYSTEM)
Before performing inspections or repairs which may cause warning messages or DTCs to occur, such as a simulation test or road test, it is necessary to activate warning notification restraint mode so that the G-BOOK center does not recognize the warnings as real ones.
Warning notification restraint mode can be entered by using the GTS or using the switch of the remote touch.
The warning notification function sends a warning ON signal, received from the combination meter assembly via CAN communication, to the G-BOOK center using the G-BOOK device if a warning is displayed in the vehicle due to a vehicle malfunction.
Warning notification restraint mode
To cancel warning notification restraint mode, turn the power switch off and on (IG) to display the service mode screen and select "Cancel" button on the screen.
Warning notification restraint mode (Using the GTS)
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (READY).
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Warning notification restraint mode (Using the switch of the remote touch)
Enter diagnostic mode of the navigation system (Click here).
PRECAUTION WHEN REPLACING COMBINATION METER ASSEMBLY
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.