Click here

LIGHTING SYSTEM Luggage Compartment Door Courtesy Switch Circuit

Click here
Click here
DTC Code DTC Name
  Luggage Compartment Door Courtesy Switch Circuit
Click here

DESCRIPTION

The main body ECU (multiplex network body ECU) detects the condition of the luggage compartment door lock assembly using this circuit.

Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.

Click here

PROCEDURE


  1. Click here

    READ VALUE USING GTS


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. Read the display on the GTS.

      Table 1. Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Luggage Courtesy SW Luggage compartment door courtesy switch signal/ON or OFF

      ON: Luggage compartment door open

      OFF: Luggage compartment door closed

      		 -
      OK
      Normal conditions listed above are displayed.

  2. Click here

    INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY


    1. Remove the luggage compartment door lock assembly (Click here).

    2. Inspect the luggage compartment door lock assembly (Click here).

      OK
      Luggage compartment door lock assembly is normal.

  3. Click here

    CHECK HARNESS AND CONNECTOR (LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))


    1. Disconnect the H10 main body ECU (multiplex network body ECU) connector.

    2. Disconnect the P14 No. 1 luggage compartment light assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      U3-3 (D+) - H10-19 (LGCY) Always Below 1 Ω
      U3-3 (D+) - Body ground Always 10 kΩ or higher
      U3-2 (E) - Body ground Always Below 1 Ω

    • OK

      REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR