| DTC Code | DTC Name |
|---|---|
| B2764 | Short to GND in Intrusion Sensor Signal Circuit |
DESCRIPTION
The intrusion sensor (theft warning ultrasonic sensor) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
If a malfunction is detected in the ISIF line, the main body ECU (multiplex network body ECU) stores this DTC.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2764 | After normal/trouble signal is output from intrusion sensor (theft warning ultrasonic sensor) as result of self-diagnosis, following malfunctions are detected:
|
|
CAUTION / NOTICE / HINT
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
PROCEDURE
CHECK HARNESS AND CONNECTOR (INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (ROOF CONSOLE BOX ASSEMBLY) - BODY GROUND)
Disconnect the H9 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
REPLACE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (ROOF CONSOLE BOX ASSEMBLY)
Replace the intrusion sensor (theft warning ultrasonic sensor) (roof console box assembly) (Click here).
CHECK FOR DTC
Clear the DTCs (Click here).
Turn the power switch on (IG), then off.
Set the theft deterrent system to "ARMED STATE".
Check that the security indicator changes from illuminated to blinking.
Set the theft deterrent system to "DISARMED STATE".
Check for DTCs (Click here).
| OK |
|---|
| DTC B2764 is not output. |
END (INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (ROOF CONSOLE BOX ASSEMBLY) WAS DEFECTIVE)
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)