Click here

THEFT DETERRENT SYSTEM, Diagnostic DTC:B2762

Click here
Click here
DTC Code DTC Name
B2762 Intrusion Sensor Signal Circuit Malfunction
Click here

DESCRIPTION


DTC No. DTC Detection Condition Trouble Area
B2762

After normal/trouble signal is output from intrusion sensor (theft warning ultrasonic sensor) as result of self-diagnosis, following malfunctions are detected:


  1. Open in ISIF line circuit

  2. Reception of signals other than normal/trouble signal

  • Intrusion sensor (theft warning ultrasonic sensor) (roof console box assembly)

  • Main body ECU (multiplex network body ECU)

  • Wire harness or connector
Table 1. *a from Auxiliary Battery *b Intrusion Sensor (Theft Warning Ultrasonic Sensor) *c Main Body ECU (Multiplex Network Body ECU) *d Roof Console Box Assembly
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - ROOF CONSOLE BOX ASSEMBLY)


    1. Disconnect the H9 main body ECU (multiplex network body ECU) connector.

    2. Disconnect the T10 intrusion sensor (theft warning ultrasonic sensor) (roof console box assembly) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H9-12 (ISIF) - T10-6 (IOUT) Always Below 1 Ω

    • OKClick here
    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR

  2. Click here

    REPLACE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (ROOF CONSOLE BOX ASSEMBLY)


    1. Replace the intrusion sensor (theft warning ultrasonic sensor) (roof console box assembly) (Click here).


  3. Click here

    CHECK FOR DTC


    1. Clear the DTCs (Click here).

    2. Turn the power switch on (IG), then off.

    3. Set the theft deterrent system to "ARMED STATE".

    4. Check that the security indicator changes from illuminated to blinking.

    5. Set the theft deterrent system to "DISARMED STATE".

    6. Check for DTCs (Click here).

      OK
      DTC B2762 is not output.

    • OK

      END (INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (ROOF CONSOLE BOX ASSEMBLY) WAS DEFECTIVE)

    • NG

      REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)