Click here

THEFT DETERRENT SYSTEM TERMINALS OF ECU

Click here
Click here
Click here

  1. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    1. A0004WXE04

      Disconnect the main body ECU (multiplex network body ECU) connectors.

    2. Measure the resistance and voltage according to the value(s) in the table below.

      Tip:

      Measure the values on the wire harness side with the connector disconnected.

      Tester Connection Wiring Color Terminal Description Condition Specified Condition
      MB-30 (BECU) - Body ground - Auxiliary battery power supply Power switch off 11 to 14 V
      MB-31 (ALTB) - Body ground - Auxiliary battery power supply Power switch off 11 to 14 V
      MB-32 (IG) - Body ground - Ignition power supply (IG signal) Power switch on (IG) → off 11 to 14 V → Below 1 V
      MB-29 (ACC) - Body ground - Ignition power supply (ACC signal) Power switch on (ACC) → off 11 to 14 V → Below 1 V
      MB-11 (GND1) - Body ground - Ground Always Below 1 Ω
      H9-3 (GND2) - Body ground W-B - Body ground Ground Always Below 1 Ω
      MB-2 (FLCY) - Body ground - Front door courtesy light switch LH input Front door LH closed (OFF) → open (ON) 10 kΩ or higher → Below 1 Ω
      MB-4 (FRCY) - Body ground - Front door courtesy light switch RH input Front door RH closed (OFF) → open (ON) 10 kΩ or higher → Below 1 Ω
      H11-3 (LCTY) - Body ground G - Body ground Rear door courtesy light switch LH input Rear door LH closed (OFF) → open (ON) 10 kΩ or higher → Below 1 Ω
      H10-6 (RCTY) - Body ground B - Body ground Rear door courtesy light switch RH input Rear door RH closed (OFF) → open (ON) 10 kΩ or higher → Below 1 Ω
      H10-19 (LGCY) - Body ground GR - Body ground Luggage compartment door courtesy light switch input Luggage compartment door closed (OFF) → open (ON) 10 kΩ or higher → Below 1 Ω
      MB-20 (HCTY) - Body ground - Engine hood courtesy switch input Engine hood open (OFF) → closed (ON) 10 kΩ or higher → Below 1 Ω
      H10-23 (TKUL) - Body ground G - Body ground Luggage compartment door unlock switch input Luggage compartment door locked → unlocked 10 kΩ or higher → Below 1 Ω

      If the result is not as specified, there may be a malfunction in the wire harness.

    3. Reconnect the main body ECU (multiplex network body ECU) connectors.

    4. Measure the voltage and resistance according to the value(s) in the table below.

      Tester Connection Wiring Color Terminal Description Condition Specified Condition
      H10-7 (LSFL) - Body ground L - Body ground Front door LH unlock detection switch input Front door LH unlocked Below 1 V
      H10-7 (LSFL) - Body ground L - Body ground Front door LH unlock detection switch input Front door LH locked Pulse generation
      H10-18 (LSFR) - Body ground W - Body ground Front door RH unlock detection switch input Front door RH unlocked Below 1 V
      H10-18 (LSFR) - Body ground W - Body ground Front door RH unlock detection switch input Front door RH locked Pulse generation
      3C-17 (LSR) - Body ground GR - Body ground Rear door LH unlock detection switch input Rear door LH or RH unlocked Below 1 V
      3C-17 (LSR) - Body ground GR - Body ground Rear door LH unlock detection switch input Rear door LH and RH locked Pulse generation
      3A-53 (LSR) - Body ground GR - Body ground Rear door RH unlock detection switch input Rear door RH or LH unlocked Below 1 V
      3A-53 (LSR) - Body ground GR - Body ground Rear door RH unlock detection switch input Rear door RH and LH locked Pulse generation
      H9-8 (SSW1) - Body ground*1 LG - Body ground Intrusion sensor cancel switch signal Intrusion sensor cancel switch not pushed Below 1 V
      H9-8 (SSW1) - Body ground*1 LG - Body ground Intrusion sensor cancel switch signal Intrusion sensor cancel switch pushed Pulse generation
      H9-12 (ISIF) - Body ground*1 P - Body ground Intrusion sensor (theft warning ultrasonic sensor) signal input No moving object detected by sensor 11 to 14 V
      H9-12 (ISIF) - Body ground*1 P - Body ground Intrusion sensor (theft warning ultrasonic sensor) signal input Moving object detected by sensor during arming preparation state or armed state Below 1 V
      H9-18 (SSCL) - Body ground*1 B - Body ground Theft warning siren drive Theft warning siren sounding (Theft deterrent system in alarm sounding state)

      Pulse generation

      (Below 1 V ← → 11 to 14 V)
      3D-14 (SH) - Body ground*2 R - Body ground Security horn drive

      Security horn sounding

      (Theft deterrent system is in alarm sounding state)

      Pulse generation

      (Below 1 V ← → 11 to 14 V)
      3D-15 (HORN) - Body ground SB - Body ground Vehicle horn drive

      Vehicle horns sounding

      (Theft deterrent system is in alarm sounding state)

      Pulse generation

      (Below 1 V ← → 11 to 14 V)

      • *1: w/ Intrusion Sensor Cancel Switch

      • *2: w/o Intrusion Sensor Cancel Switch

      If the result is not as specified, the main body ECU (multiplex network body ECU) may have a malfunction.