SMART ENTRY AND START SYSTEM(for Start Function) PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected.

    System Name See Procedure
    Parking Assist Monitor System (w/ Parallel Parking Assist Function)

    Click here

    Parking Assist Monitor System (w/o Parallel Parking Assist Function)
    Power Trunk Lid System

  2. DOOR CONTROL RECEIVER EXPRESSIONS


    1. The type of door control receiver used on this model differs according to the specifications of the vehicles. The expressions listed in the table below are used in this section.

      Vehicle Specification Part Name in Manual Actual Part Name
      for China and Taiwan Door control receiver Door control and tire pressure monitoring system receiver assembly
      except China and Taiwan Door control receiver Door control receiver

  3. PRECAUTIONS WHEN USING GTS


    1. When using the GTS with the vehicle power switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  4. PRECAUTION FOR REGISTRATION


    1. If replacing any of the following parts, refer to the Service Bulletin.


      1. Certification ECU (smart key ECU assembly)

      2. Steering lock ECU (steering lock actuator assembly)

      3. Electrical key transmitter sub-assembly

      4. ID code box (immobiliser code ECU)

      5. Power management control ECU

      6. Main body ECU (multiplex network body ECU)