REAR DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

   Click here

2. Click here

   INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

   Click here

3. Click here

   INSTALL REAR DOOR LOCK ASSEMBLY

   Note:
   

   • When reusing the removed rear door lock assembly, replace the door lock wiring harness seal with a new one.

   • Do not allow grease or dust to adhere to the door lock wiring harness seal surface.

   • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the rear door lock assembly.

   
   

   1. Apply MP grease to the sliding parts of the rear door lock assembly.

   2. When reusing the rear door lock assembly:

      
      
      1. 

         Install a new door lock wiring harness seal to the rear door lock assembly.

   3. 

      Insert the rear door lock assembly to release plate, and set them to the rear door panel.

      Table 1. Text in Illustration

      *1	Release Plate

   4. Make sure that the release plate is securely connected to the rear door lock assembly.

   5. Using a T30 "TORX" socket wrench, install the rear door lock assembly with the 3 screws.

      5.5 N*m

      56 kgf*cm

      49 in.*lbf

4. Click here

   INSTALL REAR DOOR GLASS ASSEMBLY

   Click here

5. Click here

   INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

6. Click here

   INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

   Click here

7. Click here

   INSTALL REAR DOOR NO. 1 VENT SEAL

   Click here

8. Click here

   INSTALL REAR DOOR GLASS RUN

   Click here

9. Click here

   INSTALL REAR DOOR FRAME GARNISH

   Click here

10. Click here

    CONNECT REAR DOOR WEATHERSTRIP

    Click here

11. Click here

    INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

12. Click here

    INSTALL REAR DOOR ARMREST SET BRACKET

    Click here

13. Click here

    INSTALL REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

    Click here

14. Click here

    INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

15. Click here

    INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

16. Click here

    INSTALL COURTESY LIGHT ASSEMBLY

    Click here

17. Click here

    INSTALL REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

18. Click here

    INSTALL DOOR PULL HANDLE COVER

    Click here

19. Click here

    INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

20. Click here

    INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

21. Click here

    CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

22. Click here

    INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

23. Click here

    INITIALIZE POWER WINDOW CONTROL SYSTEM

    (Click here)

24. Click here

    INSPECT POWER WINDOW OPERATION

    (Click here)