REAR DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  6. REMOVE DOOR PULL HANDLE COVER

    Click here

  7. REMOVE REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

  8. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  9. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  10. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

  11. REMOVE REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

    Click here

  12. REMOVE REAR DOOR ARMREST SET BRACKET

    Click here

  13. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  14. DISCONNECT REAR DOOR WEATHERSTRIP

    Click here

  15. REMOVE REAR DOOR FRAME GARNISH

    Click here

  16. REMOVE REAR DOOR GLASS RUN

    Click here

  17. REMOVE REAR DOOR NO. 1 VENT SEAL

    Click here

  18. REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  19. REMOVE REAR DOOR QUARTER WINDOW GLASS

    Click here

  20. REMOVE REAR DOOR GLASS ASSEMBLY

    Click here

  21. REMOVE REAR DOOR LOCK ASSEMBLY


    1. A00073SE05
      Text in Illustration
      *1 Release Plate

      Using a T30 "TORX" socket wrench, remove the 3 screws.

    2. Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

    3. When reusing the rear door lock assembly:


      1. A00067L

        Remove the door lock wiring harness seal from the rear door lock assembly.

  22. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

    Click here

  23. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

    Click here