FRONT DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

   Click here

2. Click here

   INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

   Click here

3. Click here

   INSTALL FRONT DOOR LOCK ASSEMBLY

   Note:
   

   • When reusing the removed front door lock assembly, replace the door lock wiring harness seal with a new one.

   • Do not allow grease or dust to adhere to the door lock wiring harness seal surface.

   • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the front door lock assembly.

   
   

   1. Apply MP grease to the sliding parts of the front door lock assembly.

   2. When reusing the front door lock assembly:

      
      

      1. Install a new door lock wiring harness seal to the front door lock assembly.

   3. 

      Insert the front door lock open rod to the front door lock assembly.

      Table 1. Text in Illustration

      *1	Front Door Lock Open Rod

   4. Make sure that the front door lock open rod is securely connected to the front door lock assembly.

   5. Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

4. Click here

   INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

   Click here

5. Click here

   INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

   Click here

6. Click here

   INSTALL FRONT DOOR GLASS RUN

   Click here

7. Click here

   INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

   Click here

8. Click here

   INSTALL FRONT DOOR SERVICE HOLE COVER

   Click here

9. Click here

   INSTALL FRONT DOOR ARMREST SET BRACKET

   Click here

10. Click here

    INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

11. Click here

    INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

12. Click here

    INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

13. Click here

    INSTALL COURTESY LIGHT ASSEMBLY

    Click here

14. Click here

    INSTALL DOOR PULL HANDLE COVER

    Click here

15. Click here

    INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

16. Click here

    INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

17. Click here

    INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

18. Click here

    CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

19. Click here

    INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

20. Click here

    INITIALIZE POWER WINDOW CONTROL SYSTEM

    (Click here)

21. Click here

    INSPECT POWER WINDOW OPERATION

    (Click here)