FRONT DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  5. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  7. REMOVE DOOR PULL HANDLE COVER

    Click here

  8. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  9. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  10. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  11. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

  12. REMOVE FRONT DOOR ARMREST SET BRACKET

    Click here

  13. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  14. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  15. REMOVE FRONT DOOR GLASS RUN

    Click here

  16. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  17. REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

    Click here

  18. REMOVE FRONT DOOR LOCK ASSEMBLY


    1. A0008CSE06
      Text in Illustration
      *1 Front Door Lock Open Rod

      Using a T30 "TORX" socket wrench, remove the 3 screws.

    2. Slide the front door lock assembly downward, and remove the front door lock assembly and cables as a unit.

    3. When reusing the front door lock assembly:


      1. A00094O

        Remove the door lock wiring harness seal from the front door lock assembly.

  19. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

    Click here

  20. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

    Click here