Click here

WIRELESS DOOR LOCK CONTROL SYSTEM DIAGNOSIS SYSTEM

Click here
Click here
Click here

  1. DESCRIPTION

    The ECU stores trouble codes when malfunctions occur.

    The diagnostic system allows for reading of the trouble codes from the DLC3.

    Use the GTS to help diagnose and repair the problem.

  2. CHECK DLC3


    1. Check the DLC3 (Click here).

  3. INSPECT AUXILIARY BATTERY VOLTAGE


    1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery.

  4. SELF-DIAGNOSTIC MODE (USING GTS)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Entry&Start / Utility / Wireless Door Lock Diagnosis Mode.

    5. Proceed to the next step in accordance with the prompts on the GTS screen.

      Tip:

      The electrical key transmitter uses 2 different frequencies alternately for communication. When in self diagnostic mode, one of the channels can be selected or the channels can be automatically switched.

    6. A00044VE75
      Table 1. Wireless Door Lock Buzzer Output
      *1 ON
      *2 OFF
      *3 T1: 0.125 seconds
      *4 T2: 0.5 seconds

      Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer output pattern.

    7. A0003OUE05

      Check the diagnostic outputs when the electrical key transmitter sub-assembly switch is held down. The diagnostic outputs can be checked by the interior light and wireless door lock buzzer patterns.

      Table 2. Result
      Wireless Door Lock Buzzer Output Suspected Area
      A Normal (No malfunction)
      B Register wireless code
      C Wave interference or malfunction of a related component